Micronics PCI/ISA System Board D6-IN Instrukcja Użytkownika Pobierz pdf (Strona 29)

M6DPi System Board Manual

Chapter 3: Installing the M6DPi

Installing a CPU

The M6DPi is designed to support dual Pentium Pro

processors. Follow the steps below to install the

processor(s):

1. Turn off the computer and remove its cover.

2. Locate the ZIF socket illustrated in Figure 2-1.

3. Lift the lever of the socket.

4. Locate pin 1 on the processor and pin 1 on the socket

(refer to Figure 2-1). Gently place the processor into

the socket, making sure pin 1 on the processor and

pin 1 on the socket are aligned.

5. Push the lever down until it locks into place.

6. Make sure the speed and the voltage selection jump-

ers are set correctly (refer to Chapter 2 - Jumper

Settings).

7. If you are installing a second processor, you do not

need to change any jumpers or BIOS settings. The

system will automatically recognize the new proces-

sor.

8. A VRM module must be installed on header J36

(primary CPU) and J37 (secondary CPU) for each

CPU installed. In addition, the second processor

should have the same speed rating as the main

processor.

WARNING: Pentium Pro processors require a heat-sink

with a cooling fan. Failure to provide adequate cooling of the

processor may seriously affect system performance or cause

permanent damage to the processor.

NOTE: If your operating system supports dual processors, you

may need to reconfigure or reinstall your operating system.

Refer to your software documentation for more information.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 80 81

Brak uwag

Micronics PCI/ISA System Board D6-IN Instrukcja Użytkownika Strona 29